The Firefly 800 high powered led bulb is an instant replacement for the incandescent bulb in any D cell maglite including the older style with no 'D' in the serial number. This does NOT fit Maglites that came from the factory with an LED such as ML300L.

FIREFLY 800 INSTALLATION
1. Start by unscrewing and completely removing the head of your Maglite flashlight. (if the head is not completely removed from the body you may have issues with the dropin sitting down in the head correctly).
2. Next remove the bezel and lens from the head and take out the factory reflector.
3. Insert the 800 lumen Firefly into the head(if you have a very old version of the Maglite you may need remove the extra set of rings that is on the base of the Firefly 800 first so it will sit deeper in the head (the set of rings will just slip off the bottom of the bulb).
4. Place the lens over the top of the 800 lumen Firefly reflector and screw the bezel back on to the head.
5. Remove the retaining ring and bulb from the switch tower (if you have the bi-pin bulb you can press down on the tower to eject the plastic bi-pin bulb holder). Reinstall the threaded retaining ring.
6. Screw the head of the Maglite back on to the body until it is 'snug' .
CHANGING MODES
From the ON position you can 'fast click' the switch ON/OFF/ON to get the light to change modes. Keep repeating this and the light will cycle through High, Medium, and Low modes. When you get to the brightness mode you want stop clicking. When the light has been running in any mode for more than 3 seconds it will 'memorize' that mode. When your done using the light and you power it off, the next time it is turned on it will be in the mode you last used.
From the OFF position you can gently press the switch down 'half press' just until the light comes on. If you power it ON/OFF/ON in this manner it will cycle modes from High, Medium, Low. When you find the mode you want you can fully press and 'lock' the switch into place. When the light has been running in any mode for more than 3 seconds it will 'memorize' that mode. When your done using the light and you power it off, the next time it is turned on it will be in the mode you last used.
Installation and troubleshooting

Most of us probably have a Maglite of some sort sitting around the house. Known for their superior build quality and durability, Maglite is considered to be the everyday premium flashlight. We will be taking a look at Maglite’s LED line of flashlights featuring the latest Luxeon Rebel LED.
Form Factors

The LED Maglite is available in several form factors and with two kinds of LEDs, and the type of LED is something that should be given some thought as there is a significant difference.

1. The MAGLITE Warranty The terms of Mag Instrument’s consumer warranty vary from product to product and from one region of the World to another. In general, we offer a limited lifetime warranty in the Western Hemisphere, and a ten-year limited warranty elsewhere. The warranty excludes certain parts.
2. Although Mag-Lite(R) is one of the most respected brands of flashlight, these flashlights sometimes need to be repaired. Since Mag-Lites(R) have survived being lost at the bottom of a lake or being run over by an 18-wheeler, there isn't much that can go wrong though.

Along with a letter with my return address, phone number, and a note indicating that the batteries in question were Duracell brand. A few weeks later, a package arrived from Maglite. I expected to receive my old light back with the cells removed, but instead got a. Makeup instrument windows 10 serial number and restoration kit vwr moti starter pack shiny silver 1 x moti starter pack shiny silver 1 x. Pics of: Makeup Instrument Serial Number.

LED
Older lights are frequently still seen on the shelf, so the kind of LED should be noted. The current LED Maglites use the Cree XP-E LED, and previous generation LED Maglites use the Philips Lumileds Luxeon Rebel or Luxeon III LED. The Cree XP-E is brighter and more energy efficient than both Luxeon LEDs, however, older models are often mixed with new stock on retail shelves.

The Luxeon III (left) is larger than the Luxeon Rebel (right). The Cree XP-E is mounted similar to the Luxeon Rebel, and the main difference is the square base of the XP-E. The only way to differentiate between the models is to look down the business end of the light through the clear plastic packaging.

With the D-cell lights, the serial number also indicates the type of LED inside. If the serial number begins with DLXXXXXXXXX, it is either Cree XP-E or Luxeon Rebel. If the serial number begins with DXXXXXXXXXX, it is the Luxeon III. Also, if the packaging mentions interchangeability with incandescent bulbs, then it is the Luxeon III.

Sizes
Here’s the breakdown of the sizes that are available based on LED type:

The 2AA light is an exception and is actually available in three different form factors. There are two types of the 2AA with the Luxeon Rebel – one with the flat tail cap (old), and one with the lanyard tail cap (current), similar to the regular 2AA Mini Maglite. The lanyard tail cap is preferable to the flat tail cap due to increased reliability, as well as compatibility with regular Mini Maglite tail caps (making aftermarket accessories such as “clickie” switches usable).

A common question is 2D or 3D? The gist of that decision is personal preference. The 3D is a hefty light, but it has, by far, the longest runtime. The 2D is more compact, but runtime is shorter due to the need for voltage boost. The difference in brightness between the two is not very significant, so considerations should fall on runtime and size.

Pricing & Ordering

Compared to other premium flashlights, Maglites have one major advantage – local availability. At the time of writing, regular price for the 2AA is usually around $20.

Frys and Lowe’s also sell the lights online, but after reading the previous section, you will know that ordering online is not a good idea. I was able to pick up several 2AA lights for about $10 each, at Lowe’s and Home Depot during the year-end holiday sale.

The 2D and 3D models are a little more expensive, at around $30 for either. If you are a Costco member or know someone who is, Costco has a 2AA and 3D twin-pack that is a great deal for $29.99. Again, prices vary by time and location, so this should only be interpreted as an estimate.

In The Box

For the 2AA, included in the blister packaging are: Maglite LED 2AA flashlight, 2 x AA battery, and belt holster.

For the D-cell models, only the light is included.

Batteries

While the 2AA includes two alkaline batteries and the instructions specify that only alkaline batteries should be used, it is not recommended to use alkaline batteries. The reasoning behind this is that no matter the brand, alkaline batteries can and will leak! If the light is stored in extreme conditions, such as in the glove box of a car, the chances of leakage are much higher. Instead, lithium primaries or low self-discharge (LSD) NiMH rechargeable batteries are better alternatives.

Lithium primary batteries, such as Energizer Advanced or Ultimate Lithium, are more expensive, but last longer than alkaline, perform better in cold temperatures, do not leak, and are approximately 1/3 lighter than the average alkaline. The voltages of these batteries are also slightly higher, which leads to increased output compared to alkaline.

LSD NiMH rechargeables, such as the Sanyo Eneloop that popularized low self-discharge, are able to retain charge up to one year. One thing to note about LSD rechargeables is that Duracell Pre-Charged rechargeable batteries that have a white top on the positive end are re-packaged Eneloops, and these are preferred over the black top counterparts. If you’ve ever used rechargeable batteries, you’re probably aware of the extremely high self-discharge rate that could leave the battery half-empty in a short amount of time. LSD rechargeables are an investment that will definitely pay itself off if the light is used frequently.

For D-cell lights, options are more limited, and quality alkaline batteries are a good choice. Rechargeable LSD NiMH D-cells are quiet expensive and difficult to find, though AA to D adapters can be purchased online so that primary or LSD AA’s may be used. Some adapters offer the ability to hold 2 AA’s in parallel, which will greatly increase runtime. In addition, 2 AA’s will be lighter than a D-cell.

The Light

Head
The head features a plastic lens and a smooth reflector. The beam can be focused with a quick turn of the head, and the D-cell models feature continuous cam action so which direction the head is turned will not matter.

For the 2AA model, brightness will decrease beyond a half-turn due to increased distance between the LED and the reflector, but the head can be unscrewed all the way and the light converted into “candle mode”

Body
The entire light is type-II anodized aluminum inside and out. The anodizing helps prevent corrosion, and also electrically insulates the light. (Picture below shows lights with optional anti-roll ring accessory.)

The 2AA light sports a multi-mode switch with four modes: 100%, 25%, blink, and SOS. If the light is needed for an extended period of time, one set of batteries will last for more than a day on 25% mode.

The D-cell lights feature a three position on/off switch: momentary, on, and off.

Tail Cap
D-cell lights with the Luxeon III will have a spare incandescent bulb in the tail cap. For the Luxeon Rebel models, the tail cap is not very interesting and consists of only a spring.

Performance

If you’re an incandescent Maglite user, you will certainly be surprised with the output of the LED Maglite. LEDs give off a cool white color, do not generate as much heat, and are brighter. As with incandescent Maglites, the larger models can be used as a baton if needed, although using the head as the striking surface would not be best as the LED cannot be replaced like a bulb! Below are some beamshots of the lights in spot focus:

Below are ANSI technical specifications for most of the Maglite product line.

All of the LED Maglites are regulated, which means that as the batteries are depleted and voltage drops, more current is drawn from the batteries to offset the lower voltage, resulting in consistent brightness until the batteries are completely depleted.

Runtime

If you haven’t read our article about runtime graphs and the ANSI FL1 Standard, please click here.

Accessories and Upgrades

Maglite offers a decent variety of OEM accessories for their lights, ranging from belt holders to lamps to traffic wands. I purchased a D-cell and an AA accessory pack, which came with a rubber anti-roll ring that also protects the head and lens from scratches when set down head-first, as well as a set of red, blue, and clear lenses. The D-cell accessory pack also came with a pair of mounting brackets, which I found to be convenient for storing the light. The mounting brackets are quite firm and the light snaps in with a solid THUNK.

Maglite Serial Number Check Cashing

For those with incandescent Maglites, Maglite offers a 3W drop-in LED upgrade for the 2-cell, 3-cell, and 4-cell C or D lights, which uses the Luxeon III LED. This upgrade is being discontinued due to the older LED used, but there are aftermarket upgrades (including some with the Luxeon Rebel LED) available from manufacturers such as TerraLUX. For Mini Maglites, there are no OEM upgrades, but TerraLUX and Nite-Ize make 1W LED upgrades that will certainly improve the light’s usefulness.

Conclusion

These lights are certainly quite handy to have around! The size of the 2AA makes a great every-day carry (EDC) light, or could be handy to keep in glove boxes or emergency kits (with lithium batteries installed, of course). Whether you’re an avid outdoorsman or just wandering around the house late at night trying to find your bedroom, these lights are great value and will come in handy, ready for action, for years to come.

Maglite Serial Number Check Address

Related Links